Axle Shaft for Mitsubishi Pajero: Kevlar Composite
This axle shaft for the Mitsubishi Pajero is specified around kevlar composite, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is packing that arrived crushed at the port, or a fitment that looked right on paper and failed on the bench. Both are specification problems, and both are preventable.
Specification
| Product | Axle Shaft |
|---|---|
| Vehicle application | Mitsubishi Pajero |
| Material / finish | Kevlar Composite |
| Typical use | Heavy Load Hauling |
| MOQ | 200 pieces per specification |
| Sampling | 7 working days, 3 days per revision |
| Bulk lead time | 20-30 days after approval |
| Compliance | IATF 16949 |
| Packing | 100 pieces per inner box, 200 per carton |
Material options
- Carbon Steel — selected when the part is exposed to weather and road salt
- Titanium Alloy — specified where the part sits close to a heat source
- Zinc Plated Steel — the cost-effective default for volume programmes
- Powder Coated Steel — the cost-effective default for volume programmes
- Forged Aluminium — the cost-effective default for volume programmes
Processes available
- shot blasting
- die casting
- powder coating
- gravity casting
- cold forging
- anodising
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for heavy load hauling. Related applications include wet weather riding, passenger transport, roadside assistance, rental fleets, mountain roads.
Quality and packing
- In-line inspection with AQL 2.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
How long does sampling take?
Samples leave the factory in 7 working days, and each revision round adds about 3 days once you have seen the first piece.
What testing is included?
Standard lots ship with dimensional and hardness reports. IATF 16949 documentation is issued with the shipment when your market requires it.
What happens if a lot fails inspection?
The lot is re-inspected against the golden sample, and replacement pieces ship on the next available booking at our cost.
Can the specification be held on file?
Yes. Once approved, the specification is recorded against your part number so a reorder reproduces the IATF 16949-compliant build instead of a fresh interpretation.
Ask for the current catalogue and the specification sheet for this line.
