Wheel Spacer for Toyota HiAce: Semi-Metallic Compound
This wheel spacer for the Toyota HiAce is specified around semi-metallic compound, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is premature wear on the first batch, or packing that arrived crushed at the port. Both are specification problems, and both are preventable.
Specification
| Product | Wheel Spacer |
|---|---|
| Vehicle application | Toyota HiAce |
| Material / finish | Semi-Metallic Compound |
| Typical use | Farm Use |
| MOQ | 1,000 pieces per specification |
| Sampling | 10 working days, 3 days per revision |
| Bulk lead time | 20-30 days after approval |
| Compliance | E-mark |
| Packing | 10 pieces per inner box, 200 per carton |
Material options
- Magnesium Alloy — specified where the part sits close to a heat source
- Reinforced Nylon — specified where the part sits close to a heat source
- Tempered Glass — chosen where wear resistance comes first
- Ceramic Composite — the cost-effective default for volume programmes
- Chromed Steel — used when the finish has to hold a coating
Processes available
- injection moulding
- anodising
- precision stamping
- gravity casting
- assembly line testing
- surface grinding
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for farm use. Related applications include rental fleets, daily commuting, heavy load hauling, mountain roads, delivery fleets.
Quality and packing
- In-line inspection with AQL 2.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
How long does sampling take?
Samples leave the factory in 10 working days, and each revision round adds about 3 days once you have seen the first piece.
Can the specification be held on file?
Yes. Once approved, the specification is recorded against your part number so a reorder reproduces the E-mark-compliant build instead of a fresh interpretation.
What is the minimum order quantity?
The standard MOQ is 1000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
Ask for the current catalogue and the specification sheet for this line.
