Fuel Filter for MG ZS: High Density Foam
This fuel filter for the MG ZS is specified around high density foam, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is a specification nobody had written down, or packing that arrived crushed at the port. Both are specification problems, and both are preventable.
Specification
| Product | Fuel Filter |
|---|---|
| Vehicle application | MG ZS |
| Material / finish | High Density Foam |
| Typical use | Roadside Assistance |
| MOQ | 500 pieces per specification |
| Sampling | 7 working days, 3 days per revision |
| Bulk lead time | 20-40 days after approval |
| Compliance | TUV |
| Packing | 50 pieces per inner box, 1000 per carton |
Material options
- Kevlar Composite — chosen where wear resistance comes first
- Brass — specified where the part sits close to a heat source
- Reinforced Nylon — used when the finish has to hold a coating
- Bronze — used when the finish has to hold a coating
- Neoprene — the cost-effective default for volume programmes
Processes available
- shot blasting
- die casting
- injection moulding
- electroplating
- assembly line testing
- powder coating
Fitment notes
Check whether the mounting points on your market version match the catalogue drawing — regional variants are the usual cause of a wrong first order.
Where it is used
The specification above is the one most often ordered for roadside assistance. Related applications include weekend riding, airport ground fleets, passenger transport, adventure travel, mining sites.
Quality and packing
- In-line inspection with AQL 2.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
Can the specification be held on file?
Yes. Once approved, the specification is recorded against your part number so a reorder reproduces the TUV-compliant build instead of a fresh interpretation.
What is the minimum order quantity?
The standard MOQ is 500 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
How long does sampling take?
Samples leave the factory in 7 working days, and each revision round adds about 3 days once you have seen the first piece.
What testing is included?
Standard lots ship with dimensional and hardness reports. TUV documentation is issued with the shipment when your market requires it.
Ask for the current catalogue and the specification sheet for this line.
