Steering Column for Mitsubishi Pajero: Brass
This steering column for the Mitsubishi Pajero is specified around brass, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is premature wear on the first batch, or packing that arrived crushed at the port. Both are specification problems, and both are preventable.
Specification
| Product | Steering Column |
|---|---|
| Vehicle application | Mitsubishi Pajero |
| Material / finish | Brass |
| Typical use | Construction Sites |
| MOQ | 2,000 pieces per specification |
| Sampling | 7 working days, 3 days per revision |
| Bulk lead time | 25-55 days after approval |
| Compliance | DOT |
| Packing | 100 pieces per inner box, 200 per carton |
Material options
- Carbon Steel — the cost-effective default for volume programmes
- Aluminium Alloy — the cost-effective default for volume programmes
- Kevlar Composite — the cost-effective default for volume programmes
- EPDM Rubber — specified where the part sits close to a heat source
- Nylon 66 — preferred when weight matters more than rigidity
Processes available
- sintering
- die casting
- laser cutting
- CNC machining
- surface grinding
- cold forging
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for construction sites. Related applications include airport ground fleets, heavy load hauling, off-road trails, passenger transport, ride-hailing fleets.
Quality and packing
- In-line inspection with AQL 1.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
How long does sampling take?
Samples leave the factory in 7 working days, and each revision round adds about 3 days once you have seen the first piece.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
Do you handle mixed containers?
Yes. Most programmes consolidate several part numbers into one container to keep freight sensible at 2000 pieces per line.
What is the minimum order quantity?
The standard MOQ is 2000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
Ask for the current catalogue and the specification sheet for this line.
