Brake Fluid Reservoir for Subaru Outback: ABS Plastic
This brake fluid reservoir for the Subaru Outback is specified around abs plastic, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is a fitment that looked right on paper and failed on the bench, or inconsistent hardness between lots. Both are specification problems, and both are preventable.
Specification
| Product | Brake Fluid Reservoir |
|---|---|
| Vehicle application | Subaru Outback |
| Material / finish | ABS Plastic |
| Typical use | Mountain Roads |
| MOQ | 200 pieces per specification |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | RoHS |
| Packing | 100 pieces per inner box, 1000 per carton |
Material options
- Carbon Fibre Composite — the cost-effective default for volume programmes
- Nylon 66 — specified where the part sits close to a heat source
- Polypropylene — chosen where wear resistance comes first
- Stainless Steel — specified where the part sits close to a heat source
- ABS Plastic — preferred when weight matters more than rigidity
Processes available
- laser cutting
- powder coating
- cold forging
- ultrasonic cleaning
- injection moulding
- sintering
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for mountain roads. Related applications include motocross, roadside assistance, off-road trails, night riding, track days.
Quality and packing
- In-line inspection with AQL 1.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
How long does sampling take?
Samples leave the factory in 14 working days, and each revision round adds about 5 days once you have seen the first piece.
What is the minimum order quantity?
The standard MOQ is 200 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
What happens if a lot fails inspection?
The lot is re-inspected against the golden sample, and replacement pieces ship on the next available booking at our cost.
Send the specification you are working to and we will confirm what we can match, what we would change and why.
