Drive Shaft for Chevrolet Silverado: Tempered Glass
This drive shaft for the Chevrolet Silverado is specified around tempered glass, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is packing that arrived crushed at the port, or premature wear on the first batch. Both are specification problems, and both are preventable.
Specification
| Product | Drive Shaft |
|---|---|
| Vehicle application | Chevrolet Silverado |
| Material / finish | Tempered Glass |
| Typical use | Daily Commuting |
| MOQ | 3,000 pieces per specification |
| Sampling | 7 working days, 5 days per revision |
| Bulk lead time | 20-55 days after approval |
| Compliance | TUV |
| Packing | 50 pieces per inner box, 200 per carton |
Material options
- Zinc Plated Steel — selected when the part is exposed to weather and road salt
- High Density Foam — specified where the part sits close to a heat source
- Stainless Steel — used when the finish has to hold a coating
- Ceramic Composite — specified where the part sits close to a heat source
- Titanium Alloy — chosen where wear resistance comes first
Processes available
- rubber vulcanisation
- die casting
- injection moulding
- powder coating
- sintering
- shot blasting
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for daily commuting. Related applications include coastal delivery, food delivery, rental fleets, delivery fleets, security patrols.
Quality and packing
- In-line inspection with AQL 4.0 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
How long does sampling take?
Samples leave the factory in 7 working days, and each revision round adds about 5 days once you have seen the first piece.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
What is the minimum order quantity?
The standard MOQ is 3000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
What happens if a lot fails inspection?
The lot is re-inspected against the golden sample, and replacement pieces ship on the next available booking at our cost.
Tell us the model, the fitment and the quantity and we will hold a production slot for you.
