Receiver Drier for Hyundai Tucson: Polypropylene
This receiver drier for the Hyundai Tucson is specified around polypropylene, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is warranty claims traced back to a single lot, or a fitment that looked right on paper and failed on the bench. Both are specification problems, and both are preventable.
Specification
| Product | Receiver Drier |
|---|---|
| Vehicle application | Hyundai Tucson |
| Material / finish | Polypropylene |
| Typical use | Roadside Assistance |
| MOQ | 500 pieces per specification |
| Sampling | 7 working days, 3 days per revision |
| Bulk lead time | 25-30 days after approval |
| Compliance | E-mark |
| Packing | 10 pieces per inner box, 200 per carton |
Material options
- Brass — preferred when weight matters more than rigidity
- Stainless Steel — preferred when weight matters more than rigidity
- Nylon 66 — specified where the part sits close to a heat source
- Carbon Fibre Composite — used when the finish has to hold a coating
- Titanium Alloy — preferred when weight matters more than rigidity
Processes available
- assembly line testing
- cold forging
- gravity casting
- laser cutting
- heat treatment
- anodising
Fitment notes
Check whether the mounting points on your market version match the catalogue drawing — regional variants are the usual cause of a wrong first order.
Where it is used
The specification above is the one most often ordered for roadside assistance. Related applications include off-road trails, construction sites, delivery fleets, urban courier work, daily commuting.
Quality and packing
- In-line inspection with AQL 4.0 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
What is the minimum order quantity?
The standard MOQ is 500 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
What happens if a lot fails inspection?
The lot is re-inspected against the golden sample, and replacement pieces ship on the next available booking at our cost.
How long does sampling take?
Samples leave the factory in 7 working days, and each revision round adds about 3 days once you have seen the first piece.
Send the part number, the annual volume and the target market, and we will come back with a specification and a sampling plan.
