Dual Mass Flywheel for Ford Focus: Reinforced Nylon
This dual mass flywheel for the Ford Focus is specified around reinforced nylon, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is a specification nobody had written down, or warranty claims traced back to a single lot. Both are specification problems, and both are preventable.
Specification
| Product | Dual Mass Flywheel |
|---|---|
| Vehicle application | Ford Focus |
| Material / finish | Reinforced Nylon |
| Typical use | Airport Ground Fleets |
| MOQ | 1,000 pieces per specification |
| Sampling | 14 working days, 3 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | TUV |
| Packing | 10 pieces per inner box, 1000 per carton |
Material options
- Brass — chosen where wear resistance comes first
- Kevlar Composite — chosen where wear resistance comes first
- Tempered Glass — specified where the part sits close to a heat source
- Neoprene — preferred when weight matters more than rigidity
- Ceramic Composite — preferred when weight matters more than rigidity
Processes available
- laser cutting
- gravity casting
- die casting
- electroplating
- robot welding
- assembly line testing
Fitment notes
Check whether the mounting points on your market version match the catalogue drawing — regional variants are the usual cause of a wrong first order.
Where it is used
The specification above is the one most often ordered for airport ground fleets. Related applications include wet weather riding, farm use, ride-hailing fleets, off-road trails, mountain roads.
Quality and packing
- In-line inspection with AQL 4.0 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
How long does sampling take?
Samples leave the factory in 14 working days, and each revision round adds about 3 days once you have seen the first piece.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
What happens if a lot fails inspection?
The lot is re-inspected against the golden sample, and replacement pieces ship on the next available booking at our cost.
What testing is included?
Standard lots ship with dimensional and hardness reports. TUV documentation is issued with the shipment when your market requires it.
Ask for the current catalogue and the specification sheet for this line.
