Starter Motor for Geely Coolray: Cast Iron
This starter motor for the Geely Coolray is specified around cast iron, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is a fitment that looked right on paper and failed on the bench, or reorders that did not match the approved sample. Both are specification problems, and both are preventable.
Specification
| Product | Starter Motor |
|---|---|
| Vehicle application | Geely Coolray |
| Material / finish | Cast Iron |
| Typical use | Wet Weather Riding |
| MOQ | 3,000 pieces per specification |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 25-55 days after approval |
| Compliance | IATF 16949 |
| Packing | 20 pieces per inner box, 1000 per carton |
Material options
- Neoprene — used when the finish has to hold a coating
- Natural Rubber — specified where the part sits close to a heat source
- Kevlar Composite — chosen where wear resistance comes first
- Polypropylene — used when the finish has to hold a coating
- PVC Coated Fabric — preferred when weight matters more than rigidity
Processes available
- injection moulding
- gravity casting
- rubber vulcanisation
- sintering
- robot welding
- laser cutting
Fitment notes
Confirm the fitment against the VIN or the frame number before ordering; two model years often share a name and not a part.
Where it is used
The specification above is the one most often ordered for wet weather riding. Related applications include urban courier work, rural transport, track days, weekend riding, airport ground fleets.
Quality and packing
- In-line inspection with AQL 2.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
What happens if a lot fails inspection?
The lot is re-inspected against the golden sample, and replacement pieces ship on the next available booking at our cost.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
How long does sampling take?
Samples leave the factory in 14 working days, and each revision round adds about 5 days once you have seen the first piece.
What is the minimum order quantity?
The standard MOQ is 3000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
Ask for the current catalogue and the specification sheet for this line.
