Gearbox Mount for Isuzu D-Max: Forged Aluminium
This gearbox mount for the Isuzu D-Max is specified around forged aluminium, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is reorders that did not match the approved sample, or reorders that did not match the approved sample. Both are specification problems, and both are preventable.
Specification
| Product | Gearbox Mount |
|---|---|
| Vehicle application | Isuzu D-Max |
| Material / finish | Forged Aluminium |
| Typical use | Long-Distance Touring |
| MOQ | 1,000 pieces per specification |
| Sampling | 7 working days, 3 days per revision |
| Bulk lead time | 20-40 days after approval |
| Compliance | SAE J431 |
| Packing | 50 pieces per inner box, 500 per carton |
Material options
- Reinforced Nylon — used when the finish has to hold a coating
- Ceramic Composite — specified where the part sits close to a heat source
- Natural Rubber — used when the finish has to hold a coating
- Kevlar Composite — the cost-effective default for volume programmes
- PVC Coated Fabric — chosen where wear resistance comes first
Processes available
- die casting
- gravity casting
- sintering
- laser cutting
- cold forging
- powder coating
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for long-distance touring. Related applications include long-distance touring, off-road trails, construction sites, rural transport, adventure travel.
Quality and packing
- In-line inspection with AQL 2.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
How long does sampling take?
Samples leave the factory in 7 working days, and each revision round adds about 3 days once you have seen the first piece.
Do you handle mixed containers?
Yes. Most programmes consolidate several part numbers into one container to keep freight sensible at 1000 pieces per line.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
What is the minimum order quantity?
The standard MOQ is 1000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
Share a sample or a drawing and we will quote against a written specification, not against a photograph.
