Floor Mat for Toyota Land Cruiser: Semi-Metallic Compound
This floor mat for the Toyota Land Cruiser is specified around semi-metallic compound, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is packing that arrived crushed at the port, or reorders that did not match the approved sample. Both are specification problems, and both are preventable.
Specification
| Product | Floor Mat |
|---|---|
| Vehicle application | Toyota Land Cruiser |
| Material / finish | Semi-Metallic Compound |
| Typical use | Motocross |
| MOQ | 2,000 pieces per specification |
| Sampling | 14 working days, 3 days per revision |
| Bulk lead time | 15-40 days after approval |
| Compliance | DOT |
| Packing | 20 pieces per inner box, 200 per carton |
Material options
- Zinc Plated Steel — chosen where wear resistance comes first
- Silicone — selected when the part is exposed to weather and road salt
- EPDM Rubber — selected when the part is exposed to weather and road salt
- Nylon 66 — chosen where wear resistance comes first
- Kevlar Composite — specified where the part sits close to a heat source
Processes available
- gravity casting
- heat treatment
- assembly line testing
- rubber vulcanisation
- powder coating
- shot blasting
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for motocross. Related applications include coastal delivery, airport ground fleets, construction sites, rental fleets, night riding.
Quality and packing
- In-line inspection with AQL 1.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
What is the minimum order quantity?
The standard MOQ is 2000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
Can the specification be held on file?
Yes. Once approved, the specification is recorded against your part number so a reorder reproduces the DOT-compliant build instead of a fresh interpretation.
How long does sampling take?
Samples leave the factory in 14 working days, and each revision round adds about 3 days once you have seen the first piece.
Share a sample or a drawing and we will quote against a written specification, not against a photograph.
