Parking Sensor for Toyota Fortuner: Polypropylene
This parking sensor for the Toyota Fortuner is specified around polypropylene, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is lead time that slipped twice before bulk started, or warranty claims traced back to a single lot. Both are specification problems, and both are preventable.
Specification
| Product | Parking Sensor |
|---|---|
| Vehicle application | Toyota Fortuner |
| Material / finish | Polypropylene |
| Typical use | Airport Ground Fleets |
| MOQ | 1,000 pieces per specification |
| Sampling | 10 working days, 5 days per revision |
| Bulk lead time | 15-55 days after approval |
| Compliance | SAE J431 |
| Packing | 10 pieces per inner box, 200 per carton |
Material options
- Tempered Glass — used when the finish has to hold a coating
- Stainless Steel — selected when the part is exposed to weather and road salt
- Brass — chosen where wear resistance comes first
- Chromed Steel — preferred when weight matters more than rigidity
- High Density Foam — specified where the part sits close to a heat source
Processes available
- laser cutting
- rubber vulcanisation
- precision stamping
- injection moulding
- anodising
- electroplating
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for airport ground fleets. Related applications include rental fleets, wet weather riding, mining sites, coastal delivery, off-road trails.
Quality and packing
- In-line inspection with AQL 4.0 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
What testing is included?
Standard lots ship with dimensional and hardness reports. SAE J431 documentation is issued with the shipment when your market requires it.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
What is the minimum order quantity?
The standard MOQ is 1000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
How long does sampling take?
Samples leave the factory in 10 working days, and each revision round adds about 5 days once you have seen the first piece.
Send the specification you are working to and we will confirm what we can match, what we would change and why.
