Gear Knob for Ford Focus: Reinforced Nylon
This gear knob for the Ford Focus is specified around reinforced nylon, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is a specification nobody had written down, or a fitment that looked right on paper and failed on the bench. Both are specification problems, and both are preventable.
Specification
| Product | Gear Knob |
|---|---|
| Vehicle application | Ford Focus |
| Material / finish | Reinforced Nylon |
| Typical use | Construction Sites |
| MOQ | 2,000 pieces per specification |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 15-40 days after approval |
| Compliance | CCC |
| Packing | 50 pieces per inner box, 200 per carton |
Material options
- High Density Foam — the cost-effective default for volume programmes
- Stainless Steel — selected when the part is exposed to weather and road salt
- Anodised Aluminium — preferred when weight matters more than rigidity
- Chromed Steel — selected when the part is exposed to weather and road salt
- Brass — used when the finish has to hold a coating
Processes available
- die casting
- electroplating
- precision stamping
- surface grinding
- rubber vulcanisation
- powder coating
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for construction sites. Related applications include night riding, roadside assistance, off-road trails, security patrols, rural transport.
Quality and packing
- In-line inspection with AQL 2.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
What happens if a lot fails inspection?
The lot is re-inspected against the golden sample, and replacement pieces ship on the next available booking at our cost.
How long does sampling take?
Samples leave the factory in 14 working days, and each revision round adds about 5 days once you have seen the first piece.
What is the minimum order quantity?
The standard MOQ is 2000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
Send the part number, the annual volume and the target market, and we will come back with a specification and a sampling plan.
