Drive Shaft for Suzuki Jimny: Reinforced Nylon
This drive shaft for the Suzuki Jimny is specified around reinforced nylon, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is inconsistent hardness between lots, or warranty claims traced back to a single lot. Both are specification problems, and both are preventable.
Specification
| Product | Drive Shaft |
|---|---|
| Vehicle application | Suzuki Jimny |
| Material / finish | Reinforced Nylon |
| Typical use | Rural Transport |
| MOQ | 3,000 pieces per specification |
| Sampling | 7 working days, 5 days per revision |
| Bulk lead time | 20-55 days after approval |
| Compliance | ISO/TS 16949 |
| Packing | 20 pieces per inner box, 500 per carton |
Material options
- Stainless Steel — preferred when weight matters more than rigidity
- Titanium Alloy — the cost-effective default for volume programmes
- Anodised Aluminium — used when the finish has to hold a coating
- Nylon 66 — specified where the part sits close to a heat source
- Silicone — the cost-effective default for volume programmes
Processes available
- surface grinding
- shot blasting
- gravity casting
- sintering
- powder coating
- rubber vulcanisation
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for rural transport. Related applications include farm use, urban courier work, motocross, food delivery, security patrols.
Quality and packing
- In-line inspection with AQL 1.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
What happens if a lot fails inspection?
The lot is re-inspected against the golden sample, and replacement pieces ship on the next available booking at our cost.
How long does sampling take?
Samples leave the factory in 7 working days, and each revision round adds about 5 days once you have seen the first piece.
Can the specification be held on file?
Yes. Once approved, the specification is recorded against your part number so a reorder reproduces the ISO/TS 16949-compliant build instead of a fresh interpretation.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
Send the specification you are working to and we will confirm what we can match, what we would change and why.
