Stabilizer Link for Tesla Model 3: Silicone
This stabilizer link for the Tesla Model 3 is specified around silicone, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is a fitment that looked right on paper and failed on the bench, or a specification nobody had written down. Both are specification problems, and both are preventable.
Specification
| Product | Stabilizer Link |
|---|---|
| Vehicle application | Tesla Model 3 |
| Material / finish | Silicone |
| Typical use | Mountain Roads |
| MOQ | 200 pieces per specification |
| Sampling | 14 working days, 3 days per revision |
| Bulk lead time | 15-55 days after approval |
| Compliance | SAE J431 |
| Packing | 10 pieces per inner box, 1000 per carton |
Material options
- Polypropylene — selected when the part is exposed to weather and road salt
- Sintered Metal — selected when the part is exposed to weather and road salt
- Brass — preferred when weight matters more than rigidity
- EPDM Rubber — chosen where wear resistance comes first
- Kevlar Composite — preferred when weight matters more than rigidity
Processes available
- die casting
- electroplating
- cold forging
- rubber vulcanisation
- surface grinding
- ultrasonic cleaning
Fitment notes
Confirm the fitment against the VIN or the frame number before ordering; two model years often share a name and not a part.
Where it is used
The specification above is the one most often ordered for mountain roads. Related applications include adventure travel, daily commuting, construction sites, mountain roads, motocross.
Quality and packing
- In-line inspection with AQL 1.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
What happens if a lot fails inspection?
The lot is re-inspected against the golden sample, and replacement pieces ship on the next available booking at our cost.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
What is the minimum order quantity?
The standard MOQ is 200 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
How long does sampling take?
Samples leave the factory in 14 working days, and each revision round adds about 3 days once you have seen the first piece.
Share a sample or a drawing and we will quote against a written specification, not against a photograph.
