Wheel Hub Bearing for Honda Civic: Kevlar Composite
This wheel hub bearing for the Honda Civic is specified around kevlar composite, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is a specification nobody had written down, or inconsistent hardness between lots. Both are specification problems, and both are preventable.
Specification
| Product | Wheel Hub Bearing |
|---|---|
| Vehicle application | Honda Civic |
| Material / finish | Kevlar Composite |
| Typical use | Rural Transport |
| MOQ | 200 pieces per specification |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 15-55 days after approval |
| Compliance | DOT |
| Packing | 100 pieces per inner box, 1000 per carton |
Material options
- Carbon Steel — preferred when weight matters more than rigidity
- ABS Plastic — specified where the part sits close to a heat source
- Carbon Fibre Composite — the cost-effective default for volume programmes
- Brass — selected when the part is exposed to weather and road salt
- Bronze — the cost-effective default for volume programmes
Processes available
- powder coating
- heat treatment
- rubber vulcanisation
- surface grinding
- laser cutting
- assembly line testing
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for rural transport. Related applications include ride-hailing fleets, off-road trails, construction sites, airport ground fleets, rental fleets.
Quality and packing
- In-line inspection with AQL 1.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
What is the minimum order quantity?
The standard MOQ is 200 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
Can the specification be held on file?
Yes. Once approved, the specification is recorded against your part number so a reorder reproduces the DOT-compliant build instead of a fresh interpretation.
How long does sampling take?
Samples leave the factory in 14 working days, and each revision round adds about 5 days once you have seen the first piece.
Do you handle mixed containers?
Yes. Most programmes consolidate several part numbers into one container to keep freight sensible at 200 pieces per line.
Ask for the current catalogue and the specification sheet for this line.
