MAF Sensor for Mazda BT-50: EPDM Rubber
This maf sensor for the Mazda BT-50 is specified around epdm rubber, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is documentation that arrived after the container shipped, or documentation that arrived after the container shipped. Both are specification problems, and both are preventable.
Specification
| Product | MAF Sensor |
|---|---|
| Vehicle application | Mazda BT-50 |
| Material / finish | EPDM Rubber |
| Typical use | Heavy Load Hauling |
| MOQ | 3,000 pieces per specification |
| Sampling | 7 working days, 3 days per revision |
| Bulk lead time | 15-55 days after approval |
| Compliance | REACH |
| Packing | 20 pieces per inner box, 200 per carton |
Material options
- Zinc Plated Steel — used when the finish has to hold a coating
- Tempered Glass — specified where the part sits close to a heat source
- Kevlar Composite — preferred when weight matters more than rigidity
- Chromed Steel — the cost-effective default for volume programmes
- ABS Plastic — used when the finish has to hold a coating
Processes available
- ultrasonic cleaning
- injection moulding
- die casting
- cold forging
- assembly line testing
- rubber vulcanisation
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for heavy load hauling. Related applications include passenger transport, airport ground fleets, off-road trails, long-distance touring, wet weather riding.
Quality and packing
- In-line inspection with AQL 4.0 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
What is the minimum order quantity?
The standard MOQ is 3000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
Can the specification be held on file?
Yes. Once approved, the specification is recorded against your part number so a reorder reproduces the REACH-compliant build instead of a fresh interpretation.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
How long does sampling take?
Samples leave the factory in 7 working days, and each revision round adds about 3 days once you have seen the first piece.
Ask for the current catalogue and the specification sheet for this line.
