CV Joint for Audi A4: Anodised Aluminium
This cv joint for the Audi A4 is specified around anodised aluminium, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is a fitment that looked right on paper and failed on the bench, or packing that arrived crushed at the port. Both are specification problems, and both are preventable.
Specification
| Product | CV Joint |
|---|---|
| Vehicle application | Audi A4 |
| Material / finish | Anodised Aluminium |
| Typical use | Off-Road Trails |
| MOQ | 200 pieces per specification |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 15-55 days after approval |
| Compliance | SGS |
| Packing | 10 pieces per inner box, 200 per carton |
Material options
- Cast Iron — used when the finish has to hold a coating
- Natural Rubber — preferred when weight matters more than rigidity
- Reinforced Nylon — selected when the part is exposed to weather and road salt
- Polypropylene — preferred when weight matters more than rigidity
- Brass — the cost-effective default for volume programmes
Processes available
- anodising
- gravity casting
- electroplating
- shot blasting
- surface grinding
- powder coating
Fitment notes
Check whether the mounting points on your market version match the catalogue drawing — regional variants are the usual cause of a wrong first order.
Where it is used
The specification above is the one most often ordered for off-road trails. Related applications include wet weather riding, daily commuting, passenger transport, coastal delivery, night riding.
Quality and packing
- In-line inspection with AQL 1.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
How long does sampling take?
Samples leave the factory in 14 working days, and each revision round adds about 5 days once you have seen the first piece.
Can the specification be held on file?
Yes. Once approved, the specification is recorded against your part number so a reorder reproduces the SGS-compliant build instead of a fresh interpretation.
What is the minimum order quantity?
The standard MOQ is 200 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
Ask for the current catalogue and the specification sheet for this line.
