Catalytic Converter for Hyundai Tucson: High Density Foam
This catalytic converter for the Hyundai Tucson is specified around high density foam, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is documentation that arrived after the container shipped, or lead time that slipped twice before bulk started. Both are specification problems, and both are preventable.
Specification
| Product | Catalytic Converter |
|---|---|
| Vehicle application | Hyundai Tucson |
| Material / finish | High Density Foam |
| Typical use | Roadside Assistance |
| MOQ | 200 pieces per specification |
| Sampling | 10 working days, 3 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | IATF 16949 |
| Packing | 20 pieces per inner box, 500 per carton |
Material options
- Powder Coated Steel — chosen where wear resistance comes first
- Carbon Steel — specified where the part sits close to a heat source
- Silicone — specified where the part sits close to a heat source
- Zinc Plated Steel — used when the finish has to hold a coating
- Nylon 66 — chosen where wear resistance comes first
Processes available
- injection moulding
- powder coating
- sintering
- gravity casting
- rubber vulcanisation
- cold forging
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for roadside assistance. Related applications include rental fleets, farm use, mining sites, daily commuting, urban courier work.
Quality and packing
- In-line inspection with AQL 2.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
What is the minimum order quantity?
The standard MOQ is 200 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
How long does sampling take?
Samples leave the factory in 10 working days, and each revision round adds about 3 days once you have seen the first piece.
Do you handle mixed containers?
Yes. Most programmes consolidate several part numbers into one container to keep freight sensible at 200 pieces per line.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
Ask for the current catalogue and the specification sheet for this line.
