Axle Shaft for Tesla Model 3: Ceramic Composite
This axle shaft for the Tesla Model 3 is specified around ceramic composite, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is packing that arrived crushed at the port, or premature wear on the first batch. Both are specification problems, and both are preventable.
Specification
| Product | Axle Shaft |
|---|---|
| Vehicle application | Tesla Model 3 |
| Material / finish | Ceramic Composite |
| Typical use | Roadside Assistance |
| MOQ | 2,000 pieces per specification |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 25-40 days after approval |
| Compliance | ISO/TS 16949 |
| Packing | 50 pieces per inner box, 200 per carton |
Material options
- Anodised Aluminium — specified where the part sits close to a heat source
- Polypropylene — selected when the part is exposed to weather and road salt
- Bronze — selected when the part is exposed to weather and road salt
- EPDM Rubber — used when the finish has to hold a coating
- Zinc Plated Steel — selected when the part is exposed to weather and road salt
Processes available
- sintering
- cold forging
- gravity casting
- anodising
- robot welding
- powder coating
Fitment notes
Check whether the mounting points on your market version match the catalogue drawing — regional variants are the usual cause of a wrong first order.
Where it is used
The specification above is the one most often ordered for roadside assistance. Related applications include adventure travel, airport ground fleets, security patrols, passenger transport, mining sites.
Quality and packing
- In-line inspection with AQL 4.0 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
What happens if a lot fails inspection?
The lot is re-inspected against the golden sample, and replacement pieces ship on the next available booking at our cost.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
How long does sampling take?
Samples leave the factory in 14 working days, and each revision round adds about 5 days once you have seen the first piece.
What is the minimum order quantity?
The standard MOQ is 2000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
Tell us the model, the fitment and the quantity and we will hold a production slot for you.
