Relay for Toyota Fortuner: EPDM Rubber
This relay for the Toyota Fortuner is specified around epdm rubber, which decides how it behaves in service far more than the part name does. We build to a written specification — base material, dimensions, finish and packing — and hold that specification on file so every reorder reproduces the approved piece.
The usual reason a programme changes supplier is not unit price. It is lead time that slipped twice before bulk started, or documentation that arrived after the container shipped. Both are specification problems, and both are preventable.
Specification
| Product | Relay |
|---|---|
| Vehicle application | Toyota Fortuner |
| Material / finish | EPDM Rubber |
| Typical use | Wet Weather Riding |
| MOQ | 1,000 pieces per specification |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 25-30 days after approval |
| Compliance | SAE J431 |
| Packing | 20 pieces per inner box, 200 per carton |
Material options
- EPDM Rubber — specified where the part sits close to a heat source
- Sintered Metal — the cost-effective default for volume programmes
- High Density Foam — the cost-effective default for volume programmes
- Reinforced Nylon — the cost-effective default for volume programmes
- Semi-Metallic Compound — preferred when weight matters more than rigidity
Processes available
- precision stamping
- anodising
- heat treatment
- powder coating
- sintering
- rubber vulcanisation
Fitment notes
Keep the old part until the new one is on the bench. Comparing them side by side settles questions a photograph never will.
Where it is used
The specification above is the one most often ordered for wet weather riding. Related applications include wet weather riding, airport ground fleets, construction sites, long-distance touring, ride-hailing fleets.
Quality and packing
- In-line inspection with AQL 1.5 sampling on every lot.
- Dimensional report issued against the approved drawing.
- Carton marking and barcode to your specification.
- Golden sample retained at the factory as the reorder reference.
Questions buyers ask
What happens if a lot fails inspection?
The lot is re-inspected against the golden sample, and replacement pieces ship on the next available booking at our cost.
What is the minimum order quantity?
The standard MOQ is 1000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
How long does sampling take?
Samples leave the factory in 14 working days, and each revision round adds about 5 days once you have seen the first piece.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
Ask for the current catalogue and the specification sheet for this line.
