Steel Prices: Capacity Report in Mozambique
Steel Prices: Capacity Report in Mozambique
Mozambique. Buyers working on steel prices in Mozambique have had to re-plan the last buying round. The change did not arrive all at once — it showed up first in lead time, then in price, and only afterwards in the paperwork. This report sets out what moved, why it moved, and what it means for anyone placing an order in the next few weeks.
The short version: the specification that worked last season is not automatically the specification that works now. Programmes that kept a written specification and an approved sample adjusted in days; programmes that did not are still arguing about a specification nobody had written down.
What moved
| Topic | Steel Prices |
|---|---|
| Market | Mozambique |
| Focus | Capacity Report |
| Period covered | the last buying round |
| Change recorded | 8% against the previous buying round |
| Typical lead time now | 6-10 weeks ex-factory |
| MOQ pressure | 500 pieces per specification |
| Documentation | CCC referenced in most enquiries |
Why it happened
- Freight and clearance added a second, less visible cost that most buyers discovered late.
- Specification changes were approved verbally instead of in writing, and never reached production.
- Inspection requirements tightened after 1.5% of one season's claims traced back to a single lot.
- Input cost followed — the base material moved by roughly 8% before anyone adjusted the quotation.
What buyers are doing about it
- Re-confirming the written specification before the next order instead of after it.
- Holding a golden sample at the factory as the reorder reference.
- Booking inspection before the balance payment, not after the container ships.
- Consolidating part numbers so freight per piece stays sensible.
- Asking for the test report with the goods rather than as a separate favour.
Outlook
Most of the enquiries we see from Mozambique point the same way for the last buying round: volume stays, but the tolerance for an undocumented change does not. Expect specification discipline to stay the deciding factor rather than unit price.
Practical notes for this market
- Confirm the model year and market version before ordering — regional variants are the usual cause of a wrong first order.
- State the duty cycle in writing; construction sites is not the same specification as occasional use.
- Sampling takes 14 working days, and each revision adds about 5 days.
- Keep CCC documentation with the shipment record.
Questions buyers ask
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
What testing is included?
Standard lots ship with dimensional and hardness reports. CCC documentation is issued with the shipment when your market requires it.
What is the minimum order quantity?
The standard MOQ is 500 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
How long does sampling take?
Samples leave the factory in 14 working days, and each revision round adds about 5 days once you have seen the first piece.
Send the specification you are working to and we will confirm what we can match, what we would change and why.
