Lead Time Performance: Price Watch in the Philippines
Lead Time Performance: Price Watch in the Philippines
the Philippines. Buyers working on lead time performance in the Philippines have had to re-plan the second quarter. The change did not arrive all at once — it showed up first in lead time, then in price, and only afterwards in the paperwork. This report sets out what moved, why it moved, and what it means for anyone placing an order in the next few weeks.
The short version: the specification that worked last season is not automatically the specification that works now. Programmes that kept a written specification and an approved sample adjusted in days; programmes that did not are still arguing about reorders that did not match the approved sample.
What moved
| Topic | Lead Time Performance |
|---|---|
| Market | the Philippines |
| Focus | Price Watch |
| Period covered | the second quarter |
| Change recorded | 8% against the previous buying round |
| Typical lead time now | 20-22 weeks ex-factory |
| MOQ pressure | 2,000 pieces per specification |
| Documentation | ISO 9001 referenced in most enquiries |
Why it happened
- Capacity moved first: factories that were quoting 18 weeks are now quoting 24 weeks.
- Inspection requirements tightened after 1.5% of one season's claims traced back to a single lot.
- Specification changes were approved verbally instead of in writing, and never reached production.
- Freight and clearance added a second, less visible cost that most buyers discovered late.
What buyers are doing about it
- Re-confirming the written specification before the next order instead of after it.
- Holding a golden sample at the factory as the reorder reference.
- Booking inspection before the balance payment, not after the container ships.
- Consolidating part numbers so freight per piece stays sensible.
- Asking for the test report with the goods rather than as a separate favour.
Outlook
Most of the enquiries we see from the Philippines point the same way for the second quarter: volume stays, but the tolerance for an undocumented change does not. Expect documentation to stay the deciding factor rather than unit price.
Practical notes for this market
- Confirm the model year and market version before ordering — regional variants are the usual cause of a wrong first order.
- State the duty cycle in writing; security patrols is not the same specification as occasional use.
- Sampling takes 14 working days, and each revision adds about 5 days.
- Keep ISO 9001 documentation with the shipment record.
Questions buyers ask
Can the specification be held on file?
Yes. Once approved, the specification is recorded against your part number so a reorder reproduces the ISO 9001-compliant build instead of a fresh interpretation.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
What is the minimum order quantity?
The standard MOQ is 2000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
How long does sampling take?
Samples leave the factory in 14 working days, and each revision round adds about 5 days once you have seen the first piece.
Share a sample or a drawing and we will quote against a written specification, not against a photograph.
