Trade Show Schedules: Price Watch in Jordan
Trade Show Schedules: Price Watch in Jordan
Jordan. Buyers working on trade show schedules in Jordan have had to re-plan the current season. The change did not arrive all at once — it showed up first in lead time, then in price, and only afterwards in the paperwork. This report sets out what moved, why it moved, and what it means for anyone placing an order in the next few weeks.
The short version: the specification that worked last season is not automatically the specification that works now. Programmes that kept a written specification and an approved sample adjusted in days; programmes that did not are still arguing about premature wear on the first batch.
What moved
| Topic | Trade Show Schedules |
|---|---|
| Market | Jordan |
| Focus | Price Watch |
| Period covered | the current season |
| Change recorded | 22% against the previous buying round |
| Typical lead time now | 16-18 weeks ex-factory |
| MOQ pressure | 1,000 pieces per specification |
| Documentation | DOT referenced in most enquiries |
Why it happened
- Freight and clearance added a second, less visible cost that most buyers discovered late.
- Input cost followed — the base material moved by roughly 22% before anyone adjusted the quotation.
- Capacity moved first: factories that were quoting 14 weeks are now quoting 20 weeks.
- Specification changes were approved verbally instead of in writing, and never reached production.
What buyers are doing about it
- Re-confirming the written specification before the next order instead of after it.
- Holding a golden sample at the factory as the reorder reference.
- Booking inspection before the balance payment, not after the container ships.
- Consolidating part numbers so freight per piece stays sensible.
- Asking for the test report with the goods rather than as a separate favour.
Outlook
Most of the enquiries we see from Jordan point the same way for the current season: volume stays, but the tolerance for an undocumented change does not. Expect lead time to stay the deciding factor rather than unit price.
Practical notes for this market
- Confirm the model year and market version before ordering — regional variants are the usual cause of a wrong first order.
- State the duty cycle in writing; motocross is not the same specification as occasional use.
- Sampling takes 7 working days, and each revision adds about 5 days.
- Keep DOT documentation with the shipment record.
Questions buyers ask
What is the minimum order quantity?
The standard MOQ is 1000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
What testing is included?
Standard lots ship with dimensional and hardness reports. DOT documentation is issued with the shipment when your market requires it.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
How long does sampling take?
Samples leave the factory in 7 working days, and each revision round adds about 5 days once you have seen the first piece.
Send the part number, the annual volume and the target market, and we will come back with a specification and a sampling plan.
