Cross Section Otr Tire Specification Example for Workshop Replacements: Racing Spec
Cross Section Otr Tire Specification Example for Workshop Replacements: Racing Spec
This is a worked specification for cross section otr tire in a racing spec programme. It is the document we would send a buyer who asks what exactly they are getting: the material, the dimensions that are actually controlled, the finish, and the checks that happen before anything is packed.
The racing spec version exists because the duty cycle on workshop replacements is not the same as on a showroom vehicle. Where the two are specified identically, something fails later — usually reorders that did not match the approved sample.
Example specification
| Item | Cross Section Otr Tire |
|---|---|
| Application | Workshop Replacements |
| Version | Racing Spec |
| Base material | Aluminium Alloy |
| Controlled dimensions | 5 key dimensions, recorded per lot |
| Tolerance band | ±0.05 mm |
| Finish | painted |
| MOQ | 2,000 pieces per specification |
| Sampling | 14 working days, 5 days per revision |
| Compliance | DOT |
How the example is built up
- Start from the duty cycle, not from the catalogue photograph.
- Fix the base material in writing — Aluminium Alloy, in this example.
- List the dimensions that are actually controlled and the tolerance on each.
- Name the finish and what it has to survive.
- State the inspection level and who pays when a lot fails.
Processes involved
- die casting
- electroplating
- CNC machining
- gravity casting
- powder coating
- assembly line testing
Where this example applies
Programmes that run racing spec most often specify this build for workshop replacements. Related applications include aftermarket retail, municipal fleets, dealership service, construction equipment, boat trailers.
Checks before packing
- Dimensional report against the approved drawing.
- AQL 1.5 sampling on the finished lot.
- Finish inspection under agreed lighting.
- Carton drop test on the first lot of a new packing specification.
Questions buyers ask
What is the minimum order quantity?
The standard MOQ is 2000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
Can the specification be held on file?
Yes. Once approved, the specification is recorded against your part number so a reorder reproduces the DOT-compliant build instead of a fresh interpretation.
Can you match an existing sample?
Send a sample and we will reverse-engineer the specification, then produce a counter sample for approval before any bulk starts.
What testing is included?
Standard lots ship with dimensional and hardness reports. DOT documentation is issued with the shipment when your market requires it.
Ask for the current catalogue and the specification sheet for this line.
