Backseat Car Organizer Specification Example for Dealership Service: Two-Piece Construction
Backseat Car Organizer Specification Example for Dealership Service: Two-Piece Construction
This is a worked specification for backseat car organizer in a two-piece construction programme. It is the document we would send a buyer who asks what exactly they are getting: the material, the dimensions that are actually controlled, the finish, and the checks that happen before anything is packed.
The two-piece construction version exists because the duty cycle on dealership service is not the same as on a showroom vehicle. Where the two are specified identically, something fails later — usually warranty claims traced back to a single lot.
Example specification
| Item | Backseat Car Organizer |
|---|---|
| Application | Dealership Service |
| Version | Two-Piece Construction |
| Base material | Forged Aluminium |
| Controlled dimensions | 5 key dimensions, recorded per lot |
| Tolerance band | ±0.2 mm |
| Finish | powder coated |
| MOQ | 500 pieces per specification |
| Sampling | 10 working days, 5 days per revision |
| Compliance | DOT |
How the example is built up
- Start from the duty cycle, not from the catalogue photograph.
- Fix the base material in writing — Forged Aluminium, in this example.
- List the dimensions that are actually controlled and the tolerance on each.
- Name the finish and what it has to survive.
- State the inspection level and who pays when a lot fails.
Processes involved
- rubber vulcanisation
- surface grinding
- shot blasting
- laser cutting
- heat treatment
- electroplating
Where this example applies
Programmes that run two-piece construction most often specify this build for dealership service. Related applications include municipal fleets, boat trailers, construction equipment, racing teams, camper conversions.
Checks before packing
- Dimensional report against the approved drawing.
- AQL 2.5 sampling on the finished lot.
- Finish inspection under agreed lighting.
- Carton drop test on the first lot of a new packing specification.
Questions buyers ask
Can the specification be held on file?
Yes. Once approved, the specification is recorded against your part number so a reorder reproduces the DOT-compliant build instead of a fresh interpretation.
How long does sampling take?
Samples leave the factory in 10 working days, and each revision round adds about 5 days once you have seen the first piece.
Do you handle mixed containers?
Yes. Most programmes consolidate several part numbers into one container to keep freight sensible at 500 pieces per line.
What testing is included?
Standard lots ship with dimensional and hardness reports. DOT documentation is issued with the shipment when your market requires it.
Send the specification you are working to and we will confirm what we can match, what we would change and why.
