Bike Gear System Specification Example for Emergency Vehicles: Low Maintenance Version
Bike Gear System Specification Example for Emergency Vehicles: Low Maintenance Version
This is a worked specification for bike gear system in a low maintenance version programme. It is the document we would send a buyer who asks what exactly they are getting: the material, the dimensions that are actually controlled, the finish, and the checks that happen before anything is packed.
The low maintenance version version exists because the duty cycle on emergency vehicles is not the same as on a showroom vehicle. Where the two are specified identically, something fails later — usually premature wear on the first batch.
Example specification
| Item | Bike Gear System |
|---|---|
| Application | Emergency Vehicles |
| Version | Low Maintenance Version |
| Base material | Stainless Steel |
| Controlled dimensions | 6 key dimensions, recorded per lot |
| Tolerance band | ±0.05 mm |
| Finish | as machined |
| MOQ | 2,000 pieces per specification |
| Sampling | 7 working days, 3 days per revision |
| Compliance | ECE R90 |
How the example is built up
- Start from the duty cycle, not from the catalogue photograph.
- Fix the base material in writing — Stainless Steel, in this example.
- List the dimensions that are actually controlled and the tolerance on each.
- Name the finish and what it has to survive.
- State the inspection level and who pays when a lot fails.
Processes involved
- gravity casting
- cold forging
- powder coating
- ultrasonic cleaning
- precision stamping
- shot blasting
Where this example applies
Programmes that run low maintenance version most often specify this build for emergency vehicles. Related applications include delivery vans, fleet maintenance, city buses, courier fleets, dealership service.
Checks before packing
- Dimensional report against the approved drawing.
- AQL 1.5 sampling on the finished lot.
- Finish inspection under agreed lighting.
- Carton drop test on the first lot of a new packing specification.
Questions buyers ask
How long does sampling take?
Samples leave the factory in 7 working days, and each revision round adds about 3 days once you have seen the first piece.
What happens if a lot fails inspection?
The lot is re-inspected against the golden sample, and replacement pieces ship on the next available booking at our cost.
What is the minimum order quantity?
The standard MOQ is 2000 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
What testing is included?
Standard lots ship with dimensional and hardness reports. ECE R90 documentation is issued with the shipment when your market requires it.
Tell us the model, the fitment and the quantity and we will hold a production slot for you.
