Tire Balancing Machine Specification Example for Off-Road Bikes: Quick Fit Version
Tire Balancing Machine Specification Example for Off-Road Bikes: Quick Fit Version
This is a worked specification for tire balancing machine in a quick fit version programme. It is the document we would send a buyer who asks what exactly they are getting: the material, the dimensions that are actually controlled, the finish, and the checks that happen before anything is packed.
The quick fit version version exists because the duty cycle on off-road bikes is not the same as on a showroom vehicle. Where the two are specified identically, something fails later — usually a fitment that looked right on paper and failed on the bench.
Example specification
| Item | Tire Balancing Machine |
|---|---|
| Application | Off-Road Bikes |
| Version | Quick Fit Version |
| Base material | ABS Plastic |
| Controlled dimensions | 3 key dimensions, recorded per lot |
| Tolerance band | ±0.05 mm |
| Finish | anodised |
| MOQ | 500 pieces per specification |
| Sampling | 14 working days, 3 days per revision |
| Compliance | RoHS |
How the example is built up
- Start from the duty cycle, not from the catalogue photograph.
- Fix the base material in writing — ABS Plastic, in this example.
- List the dimensions that are actually controlled and the tolerance on each.
- Name the finish and what it has to survive.
- State the inspection level and who pays when a lot fails.
Processes involved
- sintering
- anodising
- precision stamping
- rubber vulcanisation
- laser cutting
- cold forging
Where this example applies
Programmes that run quick fit version most often specify this build for off-road bikes. Related applications include trailer axles, workshop replacements, camper conversions, export programmes, aftermarket retail.
Checks before packing
- Dimensional report against the approved drawing.
- AQL 1.5 sampling on the finished lot.
- Finish inspection under agreed lighting.
- Carton drop test on the first lot of a new packing specification.
Questions buyers ask
What is the minimum order quantity?
The standard MOQ is 500 pieces per specification. Mixed sizes inside one shipment are accepted once the total reaches that figure.
How long does sampling take?
Samples leave the factory in 14 working days, and each revision round adds about 3 days once you have seen the first piece.
What happens if a lot fails inspection?
The lot is re-inspected against the golden sample, and replacement pieces ship on the next available booking at our cost.
Do you handle mixed containers?
Yes. Most programmes consolidate several part numbers into one container to keep freight sensible at 500 pieces per line.
Share a sample or a drawing and we will quote against a written specification, not against a photograph.
